Series 8HE Hot Water or Steam Oil-fired Boiler
The Series 8HE, with its rugged cast iron construction, offers commercial quality in a residential
boiler. With cast iron sections, the Series 8HE offers a multitude of performance advantages
including higher heat retention, better combustion, quiet operation and superior steam
performance. The cast iron sections on the Series 8HE are factory tested and assembled with steel
push nipples. These sections offer larger water content and increased water surface area in the
boiler. Corrosion and mineral build-up is minimized and maximum heat transfer is maintained.
This larger water content also reduces unnecessary make-up water in steam applications and
quicker start-up is facilitated by better steam generation.
Thicker Walls and Higher Mass
The thicker walls and higher mass of the Series 8HE boiler maintains a high water temperature
for a greater length of time after the burner has stopped firing. This higher heat retention reduces
short cycling for maximum efficiency.
Advanced Control Platform
The Hydrostat® Temperature Limit Control uses Thermal Targeting technology to analyze
thermostat activity and continually evaluates how much heat the building requires. To further
enhance fuel efficiency, on a call for heat, the unit will energize the circulator pump to drive the
residual latent heat from the boiler to the heating zone in an attempt to satisfy the heat demand
without firing up the burner.
Hydrostat® Enhanced Digital Display with:
- Dial-Type Settings, allow for quick and easy set-up.
- Diagnostic Lights, continually indicates which features are active and if the
control is holding the burner off for any reason. No complicated menus to
Service Made Simple
The cast iron burner mounting plate
is hinged to the boiler for a full swingout
access to the combustion chamber
while the burner is still attached
allowing for quick and easy cleaning
and servicing. From top of boiler, use
a standard flue brush to clean between
the tapered section pins.
The Series 8HE (3 & 4 section) boilers are assembled and packaged with flue
exiting the rear of the boiler. For installations requiring a top flue, simply
remove jacket top and reverse flue director to top.
Built and Backed for a Lifetime
Without question, cast iron construction offers superior durability and longer life. Each Series
8HE section is pressure tested and retested upon assembly. Your complete satisfaction on all
Series 8HE boilers is backed by a lifetime warranty* and our commitment to excellence.(see warranty statement for complete details).
There are currently no literature items in the library for this product.
- Cast Iron Sections - Factory
Tested and Assembled with Steel
- Deluxe Powder Coated Steel
- Preformed Target Wall
- Full Swing-out Service Door
- Easy Top Cleanout Access
- Rear or Top Flue Convertibility
(3 & 4 Sections)
- Built-In Air Elimination Port
- Molex quick electrical connection
- Hydrostat Combination Low
Water Cut-off and Universal
Temperature Limit Control
- DHW Priority with Overide
- Hydrostat Provides Cold-Start and
Tankless Coil Operation
- ASME Safety Relief Valve (30 psi)
- Temperature-Pressure Gauge
- Taco Circulator
- Drain Valve
- Hi-Limit Pressure Control
- A.S.M.E. Safety Relief Valve (15 psi)
- Steam Pressure Gauge
- Gauge Glass and Fittings
- Low Water Cutoff HydroLevel
- 1 1/4" Skim Tapping
Steam and Water
- Beckett AFG w/GeniSys Advanced
Burner Control, Carlin EZ-Pro or
Riello Flame Retention Burners w/
- Tankless Coil Heater
*Energy Star applies only to water boilers